Configuration & traceability
Confirm cell model and lot, pack serial, released BOM and drawings, BMS hardware, firmware and parameter revision.
Open the control method ↗Quality control & acceptance
Battery inspection & acceptance.
Agree how your batteries will be checked, which results will be recorded and what must pass before shipment.
Control the exact battery configuration.
Quality control verifies each applicable characteristic against approved drawings, configuration records, test methods and project-specific acceptance criteria. The scope is agreed for the battery, equipment and destination before production release.
Incoming & in-process control
Apply agreed cell acceptance, polarity, joint, insulation, harness, torque, workmanship and calibrated-fixture checks at the relevant build steps.
Open the control method ↗Electrical & functional
Verify voltage, sensing, current path, charge and discharge behavior, protection states, communications and charger or equipment interaction.
Open the control method ↗Mechanical & thermal
Check envelope, mounting, retention, compression where required, thermal interfaces, sensor placement, clearances and enclosure condition.
Open the control method ↗End-of-line & release
Run the agreed power-up, functional and measurement sequence; record acceptance status, deviations, rework and the released unit identity.
Open the control method ↗Packing & handover
Confirm shipment state of charge, terminal protection, labels, item count, packing record and the applicable transport and handover documents.
Open the control method ↗What is checked before each order stage.
Agree the checks and records for each stage, from the first quotation to repeat orders. Resolve open requirements through sample testing and design review.
Before quotation
Required inputEquipment duty, environment, quantity, target market and required evidence.
What you reviewProposed validation scope, acceptance assumptions and open questions.
Before prototype
Required inputReleased architecture, interfaces and prototype success criteria.
What you reviewBuild revision, prototype check plan and identified measurement points.
Before pilot
Required inputAccepted prototype results, deviations and corrective actions.
What you reviewUpdated BOM and drawings, work instructions and pilot inspection criteria.
Before production
Required inputApproved configuration, control plan and allowed process limits.
What you reviewReleased production revision, inspection flow and traceability record set.
Before shipment
Required inputAgreed release criteria, packing, labels and document scope.
What you reviewInspection status, unit or batch records, packing record and handover package.
Before repeat orders
Required inputReleased revision, approved changes, field feedback, required quantity and delivery plan.
What you reviewConfirmed configuration, updated control documents and the agreed repeat-build scope.
Make every result comparable and reviewable.
Which unit was tested?
Pack serial or sample ID, cell lot, build date and released hardware and software revision.
Review the evidence guide ↗How was it measured?
Equipment, calibration status, connection boundary, procedure, sampling interval and test conditions.
Review the evidence guide ↗Did it meet the requirement?
Acceptance limit, measured result, deviation disposition, reviewer and release status.
Review the evidence guide ↗Documents to agree with your battery order.
Unit or batch identity
Serials, cell lot and configuration revision tied to the supplied units.
Inspection record
Applicable incoming, in-process and end-of-line results with acceptance status.
UN 38.3 transport evidence
Applicable UN 38.3 test summary for the supplied cell or battery type, with shipment classification and route-specific dangerous-goods documents.
SDS / MSDS
Current safety data sheet for the supplied cell or battery where required by the customer, carrier, destination market or shipment route.
Product compliance
Applicable IEC, UL or other market-specific reports and certificates are defined for the exact product, application and destination before quotation.
Deviation & change record
Approved departures, rework disposition and reviewed component or process changes.
Shipment package
Packing, labels and applicable transport, test-summary and handover documents defined in the order.
Prepare inspection requirements for your battery.
Include your equipment, battery requirements and quantities. Add an existing drawing or configuration reference where available.